Home / Boat brands / Allures

Allures rigging

Aluminium expertise for blue-water cruising

Allures 40.9, 45.9 or 51.9: prepare your world cruise with confidence.

Full control of galvanic corrosion (stainless and aluminium isolation).

Centreboard and cutter rig: optimise your cruising sail wardrobe.

Allures Yachting: the best of both worlds

Based in Cherbourg, Allures Yachting (Grand Large group) changed blue-water sailboats with a unique concept: an aluminium hull for absolute safety in a collision, combined with a composite deck for ergonomics, performance and comfort. These centreboard boats are built to go anywhere, from the tropics to the ice. At A'gréement, we know these blue-water cruisers well, and that they tolerate no technical approximation, especially when the nearest port is 2,000 miles away.

Rigour and corrosion protection

Working on an aluminium boat takes iron discipline. The enemy is galvanic corrosion.

  • Galvanic isolation: our golden rule. Every screw, rivet and stainless part fitted to the mast or deck must be isolated. We always use isolating compounds (Tef-Gel or Duralac) and nylon washers to prevent direct stainless-to-aluminium contact that would eat into your rig.
  • Centreboard systems: the centreboard lifting system is the heart of the boat. Its control lines take high loads in an often damp environment. We inspect them and replace them with highly abrasion-resistant ropes to avoid any failure of the board control.
  • Cutter rig (staysail): almost every Allures sails with a staysail, on a furler or a removable stay. Tuning the removable stay or staysail furler is crucial to keep the mast straight. We balance the tensions so the mast stays steady in bad weather.
  • Furler maintenance: on a long voyage, the furler is safety equipment. We service the mechanisms (Profurl, Facnor or Reckmann) so they run smoothly, even after weeks of salt spray.

Allures and aluminium special

Should the mast come down for a rig service on an Allures?

It is best before a big departure. It lets us check the masthead sheaves, which work hard downwind in the trade winds, and above all check for corrosion under the mast fittings (shroud tangs, gooseneck). On aluminium, what is hidden is often what matters most.

My Allures has a composite deck. Does that make hardware simpler?

Yes and no. The composite deck allows softer shapes, but it is bolted and bonded to the aluminium hull. When replacing clutches or winches, we make sure the fastenings create no thermal bridges or conductive paths to the metal structure below. Sealing must be perfect to protect the deck core.

What type of wire for the guardrails?

On an aluminium cruising boat, we often recommend switching to Dyneema guardrails if the rules of your races or rallies allow it, or carefully checking the isolation of the stanchions. Textile removes the risk of rust and corrosion at contact points.

Do you fit textile removable stays?

Yes, it is an excellent option for an Allures. A Dyneema removable stay is much lighter and easier to handle than a steel wire flogging on deck. We fit the high-strength attachment point and the right tensioning system (tackle or quick-release lever).

A project on your Allures?

Start with a rig inspection.

See the rig inspection